By the Earthstone Materials Team · Published November 8, 2026 · Last updated: November 8, 2026
Estimating base for a road is the same math as estimating base for a driveway, just with bigger numbers. Measure the length and the width, pick the depth, convert to cubic yards, and add for compaction. The mistake that costs money is skipping the compaction allowance, because base material loses 10 to 20 percent of its volume when it is compacted. A road ordered without that allowance runs short partway down the street, and a second delivery costs more than a slightly generous first order.
The formula
Cubic yards equals length in feet times width in feet times depth in feet, divided by 27. Then add about 20 percent for compaction. Depth must be in feet, so 6 inches is 0.5 feet and 4 inches is one third of a foot. Measure the width in a few spots along the road and use the widest reading, because a road that flares at an intersection or a turnaround uses more material than the straight sections suggest. Run the numbers through our material calculator if you want a second check, and our how much material guide covers the same formula for driveways, pads, and trenches.
Worked example: a 400 foot subdivision road
Take a 400 foot road, 20 feet wide, with a 6 inch compacted base. Convert the depth first: 6 inches is 0.5 feet. Multiply 400 times 20 times 0.5, which is 4,000 cubic feet. Divide by 27, which gives about 148 cubic yards of compacted base. Add about 20 percent for compaction, which brings the loose order to about 178 cubic yards. That is the number to order for the base layer alone, before any surface stone. If the road is wider or the base is deeper, the yardage climbs fast, so measure the real width and depth rather than trusting a round number from the plans.
Worked example: a 20 foot wide private drive
Take a private drive 100 feet long and 20 feet wide, also at 6 inches compacted. Multiply 100 times 20 times 0.5, which is 1,000 cubic feet. Divide by 27, which gives about 37 cubic yards. Add about 20 percent for compaction, which brings the order to about 45 cubic yards. A shorter drive at the same width and depth is a simple fraction of the road example, which is why measuring the real length matters more than guessing from the lot size. The same formula works for any length: change the length, keep the width and depth, and the yardage follows.
Which base material for a road
Two base materials cover most road work. FDOT limerock base is the choice when the plans or the permit name it, which is common on permitted subdivision roads. Crusher run is crushed stone blended with fines that compacts into a rock-hard, stable surface, and it is used for driveways, parking pads, and road base. Both compact into a hard structural layer. Clean #57 stone is the wrong pick for a road base because it never locks together. If the plans name a material, order that material. If they do not, confirm the choice with the engineer before the first truck rolls. Still deciding? Our material selector recommends a material in six questions.
Phased ordering for multi-week projects
A subdivision road is rarely built in one day. Order the base in phases that match the build schedule, one section at a time, and keep a running count of what has been delivered against the total estimate. Finish each section with its surface layer before moving on, so a half-built stretch never sits open through a storm. Tell us the schedule when you order so deliveries land ahead of the crew, not behind it. Each delivery has a four cubic yard minimum. Same-day delivery is available on in-stock materials when you call or text (561) 489-4948 before 4:00 PM Eastern, which helps when a phase finishes early and the next section is ready sooner than planned. Request a fast quote with the road length, width, and depth, and we will confirm the quantity and the phasing with you.